This is where you talk about the NXJ software itself, installation issues, and programming talk.
Moderators: 99jonathan, roger, imaqine
I have a program running on my pc which sends motor controls to the robot using BTsend and BT recieve. All was working well until i lost my bluetooth dongle and replaced it with a new one. It now wont make a connection. The following is displayed in the console:
BlueCove version 2.1.0 on winsock
Failed to open connection to the NXT
BlueCove stack shutdown completed
I have tried removing the robot from my list of bluetooth devices and repaired the robot again and still no luck. Do i need to change any setting anywhere as the com port may have changed?
- Posts: 30
- Joined: Thu Nov 24, 2011 10:07 am
Have you tried uninstalling the BT drivers and then re-installing them?
- Active User
- Posts: 121
- Joined: Thu Feb 10, 2011 5:47 pm
- Location: London, Earth.
Return to NXJ Software
Who is online
Users browsing this forum: No registered users and 3 guests