This is where you talk about the NXJ software itself, installation issues, and programming talk.
Moderators: 99jonathan, roger, imaqine
What's the difference between the motor speed and power? Why isn't the latter available in the icommand API?
- New User
- Posts: 12
- Joined: Sun Oct 28, 2007 7:36 pm
Speed is in degrees per second. About the most you can hope for about 900 with a fully charged battery. Power is an arbitrary number, not proportional to speed. Power settings of less than 40 usually won't make the motor move.
I don't know why Brian did not put it the icommand API; Perhaps because is is not all that useful.
- Posts: 368
- Joined: Fri Jun 01, 2007 4:31 am
- Location: Berkeley, CA
Speed required a thread to constantly adjust the power level actively. With iCommand the commands are going through Bluetooth so it makes it too slow to attempt this kind of precision control.
- Site Admin
- Posts: 392
- Joined: Fri Aug 04, 2006 4:03 pm
Return to NXJ Software
Who is online
Users browsing this forum: Baidu [Spider] and 3 guests