This is where you talk about the NXJ hardware related topics such as the brick, sensors, LEGO pieces, etc.
Moderators: 99jonathan, roger, imaqine
I'm having trouble snaking the cable for the R2MeToo's UltrasonicSensor through the turntable without it interfering with the gears. Is there any secret to this? Should I tape it in place with a small piece of scotch tape? Does anyone have any photos showing a good way to position this cable.
- New User
- Posts: 8
- Joined: Sun Oct 07, 2007 12:20 am
- Location: Minnesota
I had the same issue... I ended up using a long cable and running it exposed across the back instead of threading it through the turntable. It doesn't look as tidy, but it doesn't foul the gears or get knocked out of alignment, either.
- New User
- Posts: 1
- Joined: Sun Oct 14, 2007 4:09 am
I didn't have any problem with one cable going through the center. If you look down the middle you can see if it is hitting anything, and adjust it slightly out of the way. It gave me no problems.
Putting two cables down the middle was a little much though, so if you hook up the light sensor I would use a longer cable out the back.
- Site Admin
- Posts: 392
- Joined: Fri Aug 04, 2006 4:03 pm
Return to NXJ Hardware
Who is online
Users browsing this forum: No registered users and 1 guest