Post your NXJ projects, project ideas, etc here!
Moderators: 99jonathan, roger, imaqine
How I think I will make a automatic door is to have a ultrasonic sensor on the top. The NXT brick will have a calibrate function in the beginning of the program to calibrate the ultrasonic sensor value. Then if the ultrasonic's sensor value changes, open the door and leave it open for 5 seconds after the value goes to normal. Then repeate.
I just need to base structure...
- New User
- Posts: 21
- Joined: Wed Jul 22, 2009 12:38 am
sounds fun - once that's working, you should make it so that it saves the last calibrated value to a file.
- Advanced Member
- Posts: 158
- Joined: Fri Jan 04, 2008 1:38 am
Return to NXJ Projects
Who is online
Users browsing this forum: No registered users and 0 guests